We collected information about Smart Head Flying Hours for you. Follow the liks to find out everything about Smart Head Flying Hours.
https://kb.acronis.com/content/9157
This parameter is considered informational by the most hardware vendors. Although degradation of this parameter can be an indicator of drive aging and/or potential electromechanical problems, it does not directly indicate imminent drive failure. Regular backup is recommended. Pay closer attention to other parameters and overall drive health.
http://www.cropel.com/library/smart-attribute-list.aspx
Head Flying Hours: Time a disk head spent in the data zone, rather than in the parking area or on a head ramp. The value counts down, typically from 100 to 0. The Raw value often holds the actual number of hours. 241: Total LBAs Written: The total number of 512-byte sectors written during the entire lifetime of the device. 242: Total LBAs Read
https://superuser.com/questions/429639/howto-interpret-smart-attributes
Head Flying Hours 40858023897390 => TO HEX: 0x2529 0000 292E. lowest 4 bytes 0x292E = 10.541 power on hours (as seen below) highest 4 bytes 0x2529 = ??? (milliseconds maybe? the number goes up and down without changing hours, maybe is in a binary two's complement or doesn't have any relation with time)
https://www.smartmontools.org/ticket/20
This time the value was completely different although of the same order of magnitude. After quick investigation it became quite obvious that there is something wrong with the byte order of the raw value. kotik tmp # smartctl -d ata -A /dev/sda | grep ^240 240 Head_Flying_Hours 0x0000 100 253 000 Old_age Offline - 102838696935451 kotik tmp ...
https://www.z-a-recovery.com/manual/smart.aspx
Power on hours count: Normalized values are computed similar to the above. Despite what the name suggests, the raw value of the attribute is stored using all sorts of measurement units (hours, half-hours, or ten-minute intervals to name a few) depending on the manufacturer of the device. Head flying hours count: Operating conditions information
https://www.hdsentinel.com/smart/smartattr.php
The number of times the head was retracted as a result of power loss. 230: GMR Head Amplitude: Head positioning amplitude Head moving distances between operations. 231: Hard Disk Temperature: Disk temperature The temperature inside the hard disk housing. 240: Head Flying Hours: Number of head positioning hours Time spent during the positioning ...
https://forums.tomshardware.com/threads/high-smart-values-seagate-says-its-normal.655108/
As for the Head Flying Hours, the raw value is best viewed in hexadecimal mode: 15938623635456 = 0xe7f00000000 I believe that the actual number of flying hours is stored in the lower 32-bits (= 4...
Searching for Smart Head Flying Hours?
You can just click the links above. The info is collected for you.
