We collected information about Byonics Hours for you. Follow the liks to find out everything about Byonics Hours.
AA1 Active Attenuator. The AA1 is an active / offset attenuator that can be used to help find a hidden transmitter in the last few hundred feet when a radio's s-meter is maxed out. It conects to an HT's SMA connector and an antenna, and by tuning …
It runs on 3 AA batteries for about 20 hours at 1/2 duty cycle. Because it includes a transceiver, it can be remote controlled via DTMF tones. In addition to starting and stopping the transmitter, all timing, tones, Morse code ID, and other user settings …
https://byonics.com/support
Byonics, LLC 4960 S. Gilbert Rd. #1-155 Chandler, AZ 85249 United States: VHS Special Services 1370 Trancas St # 201 Napa, CA 94558-2912 United States
Byonics carries a full line of APRS products, to allow you to track whether you are walking around, driving a car, or flying a high altitude balloon. TinyTrak Controllers. TinyTrak controllers will allow any 2-meter radio to be paired with a GPS to send location data to the APRS network.
https://www.byonics.com/accessories
The Byonics Preamp1 amplifier combines a narrow-band, bandpass filter to block out-of-band signals and noise, with a high gain InGaP HBT MMIC amplifier. The Preamp1 was designed as a front-end filter for receivers in RF-noisy environments, such as repeaters and digipeaters and instrumentation. Preamp1 Manual - version 1.0. Preamp1 - $50.
https://www.facebook.com/tinytrak
Byonics. 1,475 likes. Byonics is a family business dedicated to creating innovative electronic projects for amateur radio operators.
https://byonics.com/cables/
The TT USB cable will connect a TinyTrak3Plus, TinyTrak4, or MT-RTG to a computer USB port for configuring and operating. In addition, if the TinyTrak is set for 5V on J7 (TT3+) or JP6 (TT4) to power a Byonics GPS, the TT USB will also provide the USB 5V to power the TinyTrak. It is essentially a USB A to DB-9 female RS-232 serial adapter plus ...
https://byonics.com/mt-rtg
The MicroTrak RTG (Ready To Go) FA is a complete 10-watt APRS tracker, including a frequency agile 2-meter transmitter, a TinyTrak3 controller chip, a Byonics GPS5 receiver, and a magnet mount SMA antenna. The MT-RTG FA was designed for easy vehicle installation. It comes pre-configured with your callsign so it is literally "Ready To Go".
https://byonics.com/mobile_cables
Byonics Radio / Power Cables will connect a TinyTrak4, TinyTrak3+, WXTrak or PicCon to most amateur radio transceivers. These 18-inch cables connect to the microphone and earphone/speaker jack of the radio, and also connect to the power supply, either via a cigarette lighter plug, an Powerpole connector, or the radio microphone jack.
https://www.mobileandmonitoring.com/aprs
Byonics MicroTrak RTG. This fully plug and play setup comes with everything you would need to install APRS in your vehicle. Antenna, radio and TNC. What makes the Byonics products stand out is they have the radio and TNC built into a very small package. The unit even comes pre-program for you with whatever specifications you want. Comes in 10W ...
Searching for Byonics Hours?
You can just click the links above. The info is collected for you.
